Napa CARLYLE TOOLS 791-7136 Instrucciones De Operación página 4

OPERATING INSTRUCTIONS
This is the safety alert symbol used for the OPERATING INSTRUCTIONS section of this manual to alert you to potential
personal injury hazards. Obey all instructions to avoid possible injury or death.
1. Prepare the fuel tank for removal according to the appropriate vehicle service manual instructions and procedure. Drain the fuel tank into a
grounded storage container.
2. Pump the jack up so the fuel tank saddle adapter is close but not touching the vehicle's fuel tank. Attach the alligator clamp at the end of
one ground wire to the transmission jack. Attach the alligator clamp at the end of the other ground wire to the lift that is supporting the
vehicle. IMPORTANT: PROPER GROUNDING IS ACCOMPLISHED WITH THE ALLIGATOR CLAMPS AFFIXED TO NON-PAINTED OR
NON-COATED PARTS. THE LIFT SUPPORTING THE VEHICLE MUST ALSO BE GROUNDED TO THE EARTH.
3. Adjust the saddle adapter's arm assemblies, height adjustment tubes and support pad assemblies to fit the fuel tank configuration, and
then center and balance the tank on the saddle adapter.
4. Raise the jack so the saddle adapter makes contact with the fuel tank, and make final adjustments. Make sure the locking knobs are tight
and detent pins are inserted completely through their corresponding tubes.
5. Secure the fuel tank to the saddle adapter by wrapping the two tie-down straps completely around the tank and saddle. Insert the tie-down
straps through their buckles and pull them tight.
6. Make sure the tank is free to be lowered all the way down and there are not obstructions. The jack must be lowered all the way before the
tank can be transported.
PREVENTIVE MAINTENANCE
This is the safety alert symbol used for the PREVENTATIVE MAINTENANCE section of this manual to alert you to potential
personal injury hazards. Obey all instructions to avoid possible injury or death.
1. Always store the adapter in a well protected area where it will not be exposed to inclement weather, corrosive vapors, abrasive dust, or
any other harmful elements. The adapter must be cleaned of water, snow, sand, grit, oil, grease or other foreign matter before using.
2. Every adapter owner is responsible for keeping the adapter labels clean and readable. Use a mild soap solution to wash external
surfaces of the adapter.
3. Do not attempt to make any repairs unless you are a qualified repair person that is familiar with this equipment. Do not use the adapter
if it is damaged, cracked, broken, or missing parts. Take it out of service until replaced or properly repaired by an authorized service
center.
INSPECTION
Visual inspection should be made before each use of the adapter, checking for damaged, loose or missing parts. Each adapter must be
inspected by a manufacturer's repair facility immediately if subjected to an abnormal load or shock. Any adapter which appears to be
damaged in any way, is found to be badly worn, or operates abnormally MUST BE REMOVED FROM SERVICE until necessary repairs are
made by a manufacturer's authorized repair facility. It is recommended that an annual inspection of the adapter be made by a manufactur-
er's authorized repair facility and that any defective parts, decals or warning labels be replaced with manufacturer's specified parts. A list of
authorized repair facilities is available from the manufacturer.
PROPER STORAGE
It is recommended that the adapter be stored in a dry location.
OWNER/USER RESPONSIBILITY
The owner and/or user must have an understanding of the manufacturer's operating instructions and warnings before using
this adapter. Personnel involved in the use and operation of equipment shall be careful, competent, trained, and qualified in
the safe operation of the
WARRANTY
Please contact your local NAPA Auto Parts Store for details on warranty.
791-7136
OPERATING MANUAL FOR 791-7136
4 12/11/18