Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
OWNER'S MANUAL
CONSEQUENCES OF NOT AVOIDING HAZARDOUS SITUATIONS
WARNING
Failure to read this manual completely and thoroughly, failure to understand its OPERATING INSTRUCTIONS, SAFETY WARNINGS,
MAINTENANCE INSTRUCTIONS and comply with them, and failure to comply with the METHODS TO AVOID HAZARDOUS SITUATIONS
could cause accidents resulting in serious or fatal personal injury and/or property damage.
Saddle
Saddle Column
Locking Holes
Locking Pin
Hole
Support Column
SETUP FOR 3 TON JACK (6603ASJ)
PLEASE REFER TO THE EXPLODED VIEW DRAWING IN THIS MANUAL IN ORDER TO IDENTIFY PARTS.
IMPORTANT: In most cases the jack should work normally right out of the box but it is not unusual for air to get trapped in the jack's hydraulic
system during shipping and handling. There are several symptoms of an air trapped hydraulic system which include only partial incremental
pump stroke, jack will not lift load, jack will not sustain load or pumping feels spongy under load. The following procedure will purge air from
the hydraulic system and only needs to be done if experiencing the above mentioned conditions.
1. The (#36) saddle should be in its lowest position.
2. Close the release valve by turning the (#62) handle clockwise until it stops. Now turn the handle two full revolutions in a counterclockwise
direction and pump the handle 10 full incremental pump strokes.
3. Close the release valve and pump the jack to maximum height. Repeat steps 2 and 3 until all the air has been purged from the system.
OPERATING INSTRUCTIONS (6603ASJ)
This is the safety alert symbol used for the OPERATING INSTRUCTIONS section of this manual to alert you to potential personal
injury hazards. Obey all instructions to avoid possible injury or death.
IMPORTANT: Before attempting to raise any vehicle, check vehicle service manual for recommended lifting surfaces.
OPERATION:
1. To raise load: Turn the handle in a clockwise direction until tight. Position the jack under the load. Proceed to pump the handle in order
to raise the lift arm to the load. As the saddle at the end of the lift arm gets closer to the load, reposition the jack so the saddle will
contact the load firmly and the load is centered on the saddle. Make sure the saddle is correctly positioned. Raise the load to the desired
work height. Place jack stands of appropriate capacity at the vehicle manufacturers's recommended support areas that provide stable
support for the raised vehicle. DO NOT CRAWL UNDER VEHICLE WHILE LIFTING VEHICLE OR PLACING OR REMOVING THE
JACK STANDS! Once jack stands are positioned, turn the handle VERY SLOWLY. Lower the load to rest on the jack stands. Inspect the
relationship between the jack stands and load to make sure the setup is stable and safe. If the setup is not stable or safe, follow the
preceding steps until corrected.
6603ASJPK
CAPACITY: 3 TON ALUMINUM FLOOR JACK
WITH 3 TON ALUMINUM JACK STAND (PAIR)
Locking Pin
Saddle Column
Locking Pin
Chain
Stand Base
Bolt and Nut
ASSEMBLY INSTRUCTIONS (1003AJ)
1. Install the support column into the stand base, align the holes in the
stand base with the holes at the bottom of the support column.
2. Install the bolt through the stand base and support column and
thread the nut onto the bolt and tighten.
3. Place the saddle column into the support column.
3
MODEL 6603ASJPK
07/08/15
Publicidad
Tabla de contenido
