Hardware Reset; Error Message - Napa CARLYLE DAMM Instrucciones De Operación

AUTO POWER OFF
• The meter will auto power off after about 2 minutes idle
for power saving.
ZERO RESET
• Press for zero reset.
• Press to zero or reset the digital angle torque
adapter before the initial use. This will ensure better
accuracy.
Note:
1. During resetting process, do not vibrate or shake the
meter. Keep it at rest and in position. The angle meter
needs to be set on top the the tool it will be used with
and set in place without any motion to allow sensor
to find home position.
2. If shows. Refer to "ERROR
MESSAGE" section.

HARDWARE RESET

• If the meter does not function as stated in the operation
manual, please refer to the following steps:
• To do a hardware reset, use a paper clip to touch the
reset button under the small hole on the back of ANGLE
METER. (A pen has ink and ink can leak into the hole
and potentially gum up the reset button.)
• Another way to RESET the ANGLE METER is to remove
the battery and re-install it.

ERROR MESSAGE

LOW VOLTAGE INDICATOR
If the battery voltage is below 2.3 volts, the meter will
highlight the battery symbol momentarily and then
shut off. The meter will display a battery symbol
under the M- Memory indicator
Er4
If the meter does not reset successfully for a period
of time, will be shown. Press to do
zero-reset again. Ensure the meter is in place on the
tool at rest and not in motion
DAMM
Er5
will display if the meter is not functioning
properly. Please reset the meter if this occurs. Refer to
the section labled "HARDWARE RESET"
Er--
M
If the meter rotates too fast,
Press to zero reset the meter.
4
Press
will be shown.
Rev. 02/17/12