Napa CARLYLE DAMM Instrucciones De Operación página 6

STEP 4: PRE-TIGHTEN WRENCH
Hold on your wrench to pre-tighten the screw.
•
(eliminate the backlash of wrench)
STEP 5: START TO MEASURE ANGLE
Press to start the angle meter and immediately
•
begin your angle torque measurement.
STEP 6: STOP AND WAIT FOR LCD FLASHING TO MEASURE ANGLE
Press
When measuring angle, if a long pause is detected
•
by the meter, then the LCD screen will begin to
flash, and it will hold the angle it recorded right
before the pause. You will need to press
the screen and press
Note:
1. There are 6 LEDs to indicate the current angle
reaching 80%, 85%, 90%, 95%, 97.5% and 100%
of target angle.
2. There is also a buzzer to indicate reaching
level of target value. The interval sound means the
meter has reached 80% of the target angle. The
extended sound means you have surpassed 100%
of the set target angle.
DAMM
Pre-tighten
Press
to clear
to resume.
100% 97.5%
((...((...
((((((((...
6
Flashing
95% 90% 85%
...))...))
over 80%
...))))))))
over 100%
80%
Rev. 02/17/12