Napa CARLYLE DAMM Instrucciones De Operación página 5

FAST GETTING START
Press to power on.
•
Press or
•
Press to start the angle measurement.
•
Start rotation.
•
Rotation stop and the LCD will begin to flash
•
indicating the rotation has stopped.
STEP 1: PUT THE METER ON THE WRENCH
STEP 2: POWER ON THE METER AND RESET
Press to power on the meter or reset the
•
current reading.
The current target angle will be shown.
•
To adjust the direction of operation from POS to
•
NEG (CW to CCW), "CHANGE ANGLE
DIRECTION" NOTE: Each of these
sections should be numbered.
STEP 3: SET TARGET ANGLE
Press to toggle through the pre-set target angles
•
(M1~M9).
Press or to adjust the current angle. Note:
•
when a target number is set, it will be saved on
that memory number. Example. M1 set @ 20; if
changed to M1 set @ 21, it will be saved as 21 on
the M1 setting until altered.
DAMM
to set target angle.
Press
• Three options can be made when the LCD is flashing
1. press to record.
2. press to clear
3. press to count from current angle.
Press to select
target angle
5
M
Current target torque
or
Press to
modify target
angle
Press
Rev. 02/17/12