Panasonic TY-CE42PS20 Instrucciones De Instalación página 17

Lower the plasma display onto the ceiling unit.
Fix two screws for securing unit
those screws on the left and right sides of the ceiling
unit.
(Tightening torque: 1.5 to 2.0 N•m)
Notes
• Be sure to tighten the screws for securing unit
base to prevent the display from coming off.
• Lift the plasma display slightly, and check that it is firmly
secured in place.
7. Adjust the ceiling-hanging bracket
Direction adjustment
Loosen the two horizontal fixing bolts. After adjusting
the direction of the plasma display, retighten the
loosened bolts to fix in place.
(Tightening torque: 6 to 7 N•m)
Angle adjustment
This ceiling unit can be placed in 7 angles from 0° to
30° in 5° increments.
If you wish to adjust the angle, remove the angle
adjusting screws from the connecting pipe and select
the corresponding position of the angle adjustment
holes. Then reinsert the screws.
(Tightening torque: 3 to 4 N•m)
8. Measures to prevent falling
When taking measures to prevent the bracket from falling
down, ensure the weight of the ceiling-hanging bracket
can be supported.
To ensure that persons in the immediate vicinity will not
be struck in the event that the ceiling-hanging bracket
slips out of position, use at least one wire rope with
some slack to prevent the bracket from falling down.
• For measures to prevent bracket from falling down, use
a commercially available wire rope.
Cutout at top
to the holes for
to their
Upper insulation spacer
Hole at bottom
Lower insulation
spacer
Screw for securing unit
(M5-35)......One each on
right and left sides
Connecting pipe
Ceiling
Wire rope
Horizontal fixing bolts
Angle adjusting screws
Angle adjustment
hole positions
0° (vertical)
5°
10°
15°
20°
25°
30°
17