Connecting A Stereo Amplifier - Magnat INTERIOR IW 810 Manual Del Usuario

GB
can be used. In the AV receiver setup, the cross-over frequency of all channels should be set
to around 70 – 100 Hz where possible. Please also observe the operating instructions for your
subwoofer and AV receiver.
GENERAL INFORMATION ABOUT CONNECTING YOUR MAGNAT LOUDSPEAKERS
Please always use a good quality loudspeaker connection cable from an audio dealer. To
prevent impairment of sound quality, we recommend cables with cross-sections of at least
1 mm² for lengths up to 3 m and at least 1.5 mm² for lengths above 3 m.
Always turn off the amplifier or receiver before connecting or disconnecting loudspeaker
cables. Place the loudspeakers in their planned positions and cut the cables to the right length.
The cables for both channels should always be exactly the same length.
Strip 10 – 15 mm of insulation from the ends of the cables and twist the ends. The loudspeaker
terminals are equipped with a clamping mechanism (fig. 4). Press the terminal head down and
guide the stripped cable end into the hole on the side. On releasing the terminal head, the
cable is secured, ensuring the best possible contact.
For good sound it is imperative that the cables must be connected in such a way that the
speakers are "in phase". This means that the black negative terminals on the speakers (-) must
be connected to the negative (-) terminals on the amplifier, the red positive (+) speaker
terminals to the positive (+) amplifier terminals. To make this easier one wire of most speaker
cables is marked with a coloured strip or a ridge in the insulation.
Before switching on the system double-check all your connections and make sure that the
terminal screws are tight and that there are no short circuits caused by stray wire filaments –
this could cause serious damage to your amplifier!

CONNECTING A STEREO AMPLIFIER

Fig. 5 shows the connection of the front speaker and subwoofer to a stereo amplifier.
CONNECTING TO AN AV RECEIVER
Figs. 6 and 7 show two different methods of connecting to AV receivers.
Fig. 6: AV receiver without subwoofer output.
Fig. 7: AV receiver with subwoofer output.
Please also observe the operating instructions for your subwoofer, amplifier and AV receiver.
9