External Repeater Installation Toro Network 8000 Satellite Plastic Pedestal - Toro Turf Guard Manual De Instalación Y Configuración

External Repeater Installation - Toro Network 8000 Satellite - Plastic Pedestal
To complete this installation, you will need an EXTERNAL repeater, a power conversion board, and two 3/4"
(19mm) #10 sheet metal screws.
Step 1 Turn the power source OFF to the Network 8000 satellite controller and remove the front plastic door.
Step 2 Mount the power conversion board on the inside wall of the pedestal using the adhesive back.
Step 3 Mount the repeater on the outside wall of the pedestal using two 3/4" (19mm) #10 sheet metal screws.
Step 4 Using a 1/4" (6.4mm) drill bit or larger, drill a hole through the sidewall of the pedestal and pull the
repeater cable through to the inside.
Step 5 Strip the end of the cable coming from the repeater so an inch or more of the two wires inside is exposed.
Step 6 Locate the power connector cable (the cable that would otherwise connect the power conversion board to
an internal repeater) and cut one end just below the white plug, cutting both black and red wires.
Step 7 Using pliers and two of the splice connectors provided, splice the cables together, as shown in
Figure 16. The red wire on the power connector cable attaches to the white wire on the repeater cable
and the black wire connects to the black wire.
Step 8 Connect the power supply board in the same way as was done in the LTC Plus installation.
Step 9 Seal all the remaining holes in the pedestal with sealing tape and/or foam gaskets.
Step 10 Turn the power source back ON to the satellite.
Step 11 Record the repeater ID and location in the Installation Log.
Figure 16
The red power wire is
connected to the white repeater
wire.
Red
Black
The black power wire is
connected to the black
White
Black
repeater wire.
STA 1
STA 2
STA 3
STA 4
STA 5
STA 6
STA 7
STA 8
STA 9
STA 10
STA 11
STA 12
STA 13
9