Installation; Installing The Wall Bracket - 3M Digital Board Guía De Seguridad Del Producto

3M™ Digital Board

Installation

Note: Photos and/or illustrations may not match exactly the hardware provided.

Installing the Wall Bracket

Unpacking Wall Bracket and Hardware
1. Stand the shipping container on its bottom side on the floor.
. Open the top side of the shipping container.
3. Remove the Digital Board, pen tray and accessories from the shipping container.
To reduce the risk associated with muscle strain:
• Always use more than one person when installing or removing the 3M Digital Board
. Locate and remove the wall bracket and hardware taped to the hanger bracket on the back of the Digital
Board.
Installation for a Hollow Wall-Drywall
• Install the 3M Digital Board on a wall with 1/-inch-thick drywall minimum.
• Use only 3M recommended wall mounting hardware.
• Follow all installation instructions carefully.
• Make sure mounting screws are properly sized to handle the weight of the 3M Digital Board.
• Make sure mounting hardware is securely anchored to a solid structure.
• Proper installation must be performed by qualified service technicians, as outlined in the installation
instructions. Failure to do so could result in serious injury and/or damage to the 3M Digital Board.
1. Determine the desired location of the unit.
. While holding the bracket in place, use a
carpenter's level to ensure the proper level and then
mark a minimum of three hole locations on the wall
– one at each end of the mounting bracket and one
in the middle. Ensure that no studs are behind the
hole locations.
Note: Drawings may not depict actual hardware used.
© 3M 006. All Rights Reserved.
WARNING
m WARNING
Installation
7