Hughes & Kettner BASSKICK Serie Manual De Instrucciones página 9

BassKick 200 & 300
The amp is too quiet.
• A device that is operated in the loop causes level losses. The effects
pedal must be levelled by means of its input/output controller.
The amp sounds too dull
• The tweeter is switched off
8
Maintenance and care
The BassKick™ amps are maintenance-free. There are, however, some
basic rules, the compliance with which secures the high useful life of
your amp:
• Do always provide for a technically unobjectionable device periphery!
• Do always provide for free air circulation at the cooling surface of
your amp.
• Do in any case avoid heavy mechanical shocks, extreme heat and
the permeation of dust and moisture.
• Do meticulously observe the specifications of additional devices.
Do never connect outputs with too large levels (e.g. power
amplifiers) to the inputs of the amp.
• Do always check the existing mains voltage before connecting
the amp to the mains supply. In case of doubt, contact the stage
technician, caretaker or similar persons.
• Please do never try to repair your amp yourself! Even the exchange
of internal fuses should be carried out by an experienced technician
only.
• The housing surface or the metal surfaces are at best cleaned with a
soft dry cloth. Do in no case use alcohol or other solvents!
9
Technical Data
Security Specifications
Mains input voltages: 240V, 220-230V, 117V, 100V
Primary fuses: 240V
220-230V
117V
100V
Secondary fuses:
Power consumption:
Ambient air temperature in operation:
Inputs
INST. INPUT passive: Socket:
Input impedance:
Sensibility:
max. input level:
INST. INPUT active: Socket:
Input impedance:
Sensibility:
max. input level:
FX LOOP-Return: Socket:
Input impedance:
max. sensibility:
max. input level:
Outputs
FX LOOP-Send: Socket:
Output impedance:
Output level:
LINE OUT: Socket:
Output impedance:
Output level:
Headphones: Socket:
Impedance:
Speaker: Socket:
Impedance:
Speaker equipment: 1 x 15" Eminence Bass, 4 Ohm
1 x Leson ceramics tweeter, 4 Ohm
Cutoff frequency: 5 kHz
Dimensions (w,h,d) and weight:
BK 200
Dimensions: 551 x 604 x 385 mm
Weight: 32 kg
70 lbs
BK 200 BK 300
T1,25A T2A
T1,25A T2A
T2,5A T4A
T2,5A T4A
2 xT3,15A 2 xT4A
370 watts 615 watts
0-35 degrees Celsius
Jack, unsymmetrical
1 MOhm
- 22 dBV
+ 2 dBV
Jack, unsymmetrical
1 MOhm
- 11,5 dBV
+ 13,5 dBV
Jack, unsymmetrical
48 kOhm
- 10 dBV
+6,5 dBV
Jack, unsymmetrical
220 Ohm
- 6 dBV
XLR male, symmetrical
1.8 kOhm
+ 4 dBV
Stereo jack
8-200 Ohm
Jack, unsymmetrical
4-8 Ohm
BK 300
611 x 625 x 385 mm
36 kg
80 lbs
9