AR Elite Serie Guia De Inicio Rapido página 7

Using the Aux In input
Use the audio cable included with this speaker to
connect the audio output from your device to the
Aux In audio input on the speaker's back panel (you
might need to open the rubber flap protecting the
jack). The speaker automatically switches to the Aux
In audio.
If you're using a single speaker, the
white you're using the Aux In input. If you're using
two, the button turns blue, and the stereo link with
the other speaker is turned off while you're using
the Aux In input.
To listen to Bluetooth audio again, unplug the cable
from the speaker's Aux In jack.
Using Multi-Mode Lighting
The Lighting Mode and Color buttons give you
control over this speaker's built-in multi-mode
lighting. You can use the lighting whether the
speaker's on or off.
When the speaker's off...
Press the Mode button to turn white light on or off.
When the speaker's on...
Press the Mode button to cycle through the multiple
lighting modes:
Solid on gives you a solid light of your color
choice—just press the Color button to see the
options.
Breathe mode slowly fades up and down light in
your color choice (press Color to see the options).
Dance mode and Party mode
follow the beat of your music and cycle through
the colors.
Press the Color button to cycle through the 8
available colors for Solid on and Breathe modes.
button turns
make the lights
Speaker back
IMPORTANT: The Aux In
input plays your music on
one speaker only. For two-
speaker stereo, you must use
Bluetooth with two speakers
linked for stereo playback.
Speaker top
Multi-Mode Lighting Demo
This speaker has a lighting
demo mode that shows off all
of the lighting options.
To activate/deactivate the
lighting demo: Make sure
the speaker's on. Then press
and hold Mode and Color at
the same time for 10 seconds
(until the demo light show
starts or stops).
7