Checking The Oil Level - Cub Cadet SS470 Manual Del Operador

4-cucle
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Removing Old Trimming Line and Obstructions
If necessary, remove any old trimming line and/or obstructions from
the cutting head.
1. Firmly press in the tabs on the cutting head (Fig. 16).
2. Remove the spool cover (Fig. 16).
3. Remove any old trimming line and/or obstructions.
4. Use a clean cloth to clean the inner reel, outer spool and spool
cover (Fig. 16).
5. Align the tabs on the spool cover with the holes on the outer
spool (Fig. 16). Push the spool cover onto the outer spool until
the tabs securely snap into the holes.

CHECKING THE OIL LEVEL

WARNING:
OVERFILLING THE CRANKCASE MAY
CAUSE SERIOUS PERSONAL INJURY. Check the oil level
before each use. The importance of maintaining the proper
oil level cannot be overemphasized.
1. Stop the engine and allow it to cool.
2. Set the unit on a flat, level surface, such as a workbench or
table. The cutting head shield should hang over the edge so that
the engine is level (Fig. 17).
NOTE: Failure to keep the engine level may cause the oil to overfill.
3. Clean the area around the oil fill plug (Fig. 18) to prevent debris
from entering the oil fill hole.
4. Unscrew the oil fill plug.
5. Look into the oil fill hole; use a flashlight if necessary. The oil
level should just touch the bottom thread of the oil fill hole
(Fig. 19). If the oil level is too low, add oil to the oil fill hole until
the oil level touches the bottom thread of the oil fill hole.
NOTE: DO NOT overfill the crankcase.
6. Wipe up any oil that may have spilled.
7. Reinstall the oil fill plug.
NOTE: Make sure the O-ring is in place on the oil fill plug (Fig. 18).
Tab
Hole
Oil Fill Plug
O-Ring
Oil Fill Hole
Maximum
Oil Level
13
Spool Cover
Inner Reel
Outer Spool
Fig. 16
Fig. 17
Fig. 18
Fig. 19

Publicidad

Tabla de contenido

Solución de problemas

loading

Tabla de contenido