Fuel And Lubricants - Altrad Belle SF460 Manual Del Operador

GB
Washing the machine
Control tighten bolts
V-belt
GB
ENGINE OIL
FUEL
VIBRATOR
HOUSING
BEARINGS
The bearings in the vibrator housing have been coated with a high temperature grease at the factory. In the event of repair, the bearings
will need the application of grease, which is to be liberally applied to the roller race (but not excessively), before replacement of the covers.
For Maintenance Schedule, please see Page 13.
WARNING
Service & Maintenance
Washing (high pressure)
Keep the machine clean.
CAUTION
Do not spray water directly on electric components or the instrument panel. Put a plastic bag
Bolted joints – Check
Check and, where necessary, tighten screws and nuts.
V-belt – Checking
1. Remove the protective cover and inspect the V belt.
2. To adjust belt tension, loosen the four engine plate bolts and slide it into position.
3. Tighten the bolts and replace the protective cover.
Never run the machine without the protective cover over the V
WARNING
belt.

Fuel And Lubricants

Honda: Use SAE 15W/40 Volume: 0.6 (0.65 qts)
Robin: Use SAE 10W/30 Volume: 0.6 l (0.65 qts)
Use ordinary grade petrol (unleaded)
Honda: Volume: 3.6 l (3.8 qts)
Robin: Volume: 3.8 l (4.0 qts)
Use SHELL Stamina EP2 Grease or
Use TOTAL Multis Complex EP2 Grease
24
Use only the frame lifting hook (1) to lift the machine.