Safety Decals, Location/Description; Pre-Start Checks; Operation - Altrad Belle SF460 Manual Del Operador

5. Lifting point
Before start
Follow the general safety precautions. Check that daily maintenance has been carried out. We also recommend that you read the
instruction manual for the engine that was delivered with the machine.
1. Check the oil level in the engine.
2. Fill the engine (cold engine) fuel tank with fuel.
3. Check that all operating controls are working.
4. Ensure that there are no oil leaks and that all screw joints are tightened.
CAUTION On new machines the engine oil must be changed after 20 working hours.
Honda Petrol Engine
Stopping the engine
1. Push in the throttle and let the engine run on idle for a minute.
2. Turn the engine switch to the O position.
3. Close the fuel cock.
Starting the engine
1. Open the fuel cock.
2. Put the throttle lever to middle position.
3. Close the choke if the engine is cold; if the engine is warm open the choke.
4. Turn the engine switch to the I position.
5. Pull back the handle of the recoil starter slowly until resistance is felt, then release the handle
and pull sharply until the engine starts.
6. Open up the choke gradually until it is fully open.
7. Let the engine run on idle for a few minutes before running it at full capacity.

Safety Decals, Location/Description

1. The operator must read the
safety manual, and the
operation and maintenance
instructions before using the
machine.
3. Warning, hand and arm
entanglement. Never reach into
the hazardous area.

Pre-Start Checks

4. Petrol
6. Use ear protectors

Operation

31
2. Warning - hot surfaces in the
engine compartment. Do not
touch.
Throttle Lever
Choke Lever
Fuel ON/OFF
Lever.
Stop
Switch