GE GXSF35E Manual Del Propietario E Instrucciones De Instalación página 16

About the water softener system.
Service: Electronic Demand Time Features and Service
To remove an error code: 1. Unplug transformer.
Service: Timer/Softener, Service Checkout Procedure
If you are not getting soft water, and an error
code is not displayed, use the procedures below
to find the problem. First make the following
visual checks.
VISUAL CHECKS:
1. Is there electrical power to the outlet the
16
ERROR CODE
DISPLAYED ERR 01
POSSIBLE DEFECT • Motor
inoperative
• Wiring
harness or
connection
to switch
• Position
switch
• Control
2. Correct defect.
3. Plug transformer in.
4. Wait for at least 6 minutes. The error code will return if the reason for
the error code was not corrected.
water softening system transformer is
plugged into?
NO SOFT CONTROL SHOWS
WRONG TIME AND DAY,
WATER
AND/OR IS FLASHING.
Check electrical
power to control
CONTROL
(outlet, transformer,
DISPLAY
power cable, all
BLANK.
connections).
CONTROL DISPLAY SHOWS
CORRECT TIME AND DAY
AND IS STEADY.
ERR 02
• Position • Motor
switch inoperative
or wiring
harness
• Control • Control
2. Is there sufficient salt in the storage tank?
3. Is the softener bypass valve directing water
for soft water service?
4. Is the valve drain hose open to the drain,
not more than 8' above the softener, and
unobstructed? If hose is above 8', see page 7,
section 4.
If you do not find a problem with the visual checks,
continue below.
Electrical power was off.
Reset the correct time of
day.
NO POWER
POWER OK
Do manual
diagnostics.
ERR 03 ERR 04
• Position
switch or
wiring
harness
• Control
Investigate reason for
power loss.
REPAIR AS
Do manual
NEEDED
diagnostics to
verify proper
function.
CONTROL
DEFECTIVE
ERR 05
• Control