Safety Instructions - ABB JPC-01 Manual Del Usuario

JPC-01 User's manual
About this manual
This manual introduces the installation and start-up of the JPC-01
network communication adapter module. This manual is intended
for the people who are responsible for installing, commissioning
and using a JPC-01 module with an ABB drive. The reader is
expected to have a basic knowledge of electrical fundamentals,
electrical wiring practices, the drive, and the use of the drive
control panel.

Safety instructions

WARNING! All electrical installation and maintenance
work on the drive should be carried out by qualified
electricians only.
The drive and adjoining equipment must be properly earthed.
Do not attempt any work on a powered drive. After switching off the
supply voltage, always allow the intermediate circuit capacitors to
discharge for 5 minutes before working on the drive, the motor or
the motor cable. It is good practice to check (with a voltage
indicating instrument) that the drive is in fact discharged before
beginning work.
These warnings are intended for all who work on the drive.
Ignoring the instructions can cause physical injury or death, or
damage the equipment.
For complete safety instructions see the drive manuals.
JPC-01 User's manual 3