Andis AAC-1 Instrucciones De Uso Y Cuidado página 3

USING THE ATTACHMENT COMBS
(Some models do not have combs and sizes will vary by kit)
You can set the blades for a longer cut by using any of the attachment
combs made for your Andis clipper. The combs mount easily; simply slip the
cutter blade teeth into comb and snap the comb down. To remove, simply
snap off (Figures A & B). These attachment combs guide hair into the blades
and give you precise control of hair lengths. The length of trim is indicated
on the attachment comb. Use the chart to find the approximate lengths of
cut. Different blade angles in relation to the skin, thickness and texture of
the hair will vary the cutting length.
CLIPPING GUIDE
Description Clipping Direction
Standard Andis Blade With hair grain
Against hair grain
1/16" Attachment Comb With hair grain
Against hair grain
1/8" Attachment Comb With hair grain
Against hair grain
1/4" Attachment Comb With hair grain
Against hair grain
3/8" Attachment Comb With hair grain
Against hair grain
1/2" Attachment Comb With hair grain
Against hair grain
5/8" Attachment Comb With hair grain
Against hair grain
3/4" Attachment Comb With hair grain
Against hair grain
7/8" Attachment Comb With hair grain
Against hair grain
1" Attachment Comb With hair grain
Against hair grain
4
Approx. Length of Cut
Fine Coarse
1/16" (1.6 mm) 3/16" (4.8 mm)
1/32" (0.8 mm) 1/8" (3.2 mm)
3/16" (4.8 mm) 5/16" (7.9 mm)
3/32" (2.4 mm) 5/32" (4.0 mm)
1/4" (6.4 mm) 3/8" (9.5 mm)
1/8" (3.2 mm) 1/4" (6.4 mm)
3/8" (9.5 mm) 1/2" (12.7 mm)
1/4" (6.4 mm) 3/8" (9.5 mm)
1/2" (12.7 mm) 5/8" (15.9 mm)
3/8" (9.5 mm) 1/2" (12.7 mm)
5/8" (15.9 mm) 7/8" (22.2 mm)
1/2" (12.7 mm) 5/8" (15.9 mm)
3/4" (19.0 mm) 1" (25.4 mm)
5/8" (15.9 mm) 7/8" (22.2 mm)
7/8" (22.2 mm) 1-1/8" (28.6 mm)
3/4" (19.0 mm) 1" (25.4 mm)
1" (25.4 mm) 1-1/4" (31.8 mm)
7/8" (22.2 mm) 1-1/8" (28.6 mm)
1-1/8" (28.6 mm) 1-3/8" (34.9 mm)
1" (25.4 mm) 1-1/4" (31.8 mm)
A
C
ADJUSTMENT
LEVER
E
OIL
CLIPPER BLADE ADJUSTMENT
Your Andis adjustable clipper blade set is easy to adjust. From coarse to
fine cuts, all that is needed is a flick of the adjustment lever with your
thumb. In the upright position, the blades are set for the finest, or shortest
cuts (Figure C).
B
SNAP!
D
POWER SCREW
F
5