lauson Audio CP441 Manual De Instrucciones página 6

Use Clock
to setup the time of the unit
1.connect the ac on(
2.short according to the time button, the time will flashing on the lcd display.
Press
3. BACK、NEXT to select the number of the time. you can setup the time
format by 12h or 24h.
4.press time button to confirm.
5.then you can set the hour and the minute with the same method of steps 3-4.
6. after setup the unit time, long press the time button can setup the unit begin working time ,
with the same method of steps 3-4.
Note: after setup the beginning time, the lcd will display the radio/cd/usb/aux mode,
Press the BACK or NEXT to choose the mode, then it press time button to affirm, otherwise
it play usb or aux mode first.
Radio
Radio reception
1.Press FUNCTION button select RADIO mode.
2. Tune to required station by press BACK/TUNE DN or NEXT/ TUNE UP
Manual Tuning: Rotate BACK or NEXT and then release within 1 sec.
Auto Tuning: Press the play/pause button enter the automatic channel
scan mode, and to be put automatically sets.
Preset Channel:(FM 30 Preset memories)
(1) Press BACK or NEXT Select desired station.
(2) Press play/pause button once , the MEMORY number indicator begins steady
in the display.
(3) Push play/pause button repeatedly to select the desired number.
(4) Press PROGRAM button to save that station.
(5) Repeat steps (1) to (4) procedures for other stations.
3.After end of program. Press play/pause button repeatedly to start play the frequency
that you selected.
4.Push [VOL-]or [VOL +] to adjust the volume.
5.Extend TELESCOPIC ANTENNA to its full length if you are listening to FM broadcasting.
6.Turn off the radio by press FUNCTION button select other mode or press power
button to off the unit.
7.Switch on again after shut down,the memory frequency still exists.
The following operation must be in standby mode)
EN-5
.
.