WEG CFW500-IOR-B Guía De Instalación, Configuración Y Operación página 9

Table 1: Settings of switches to select the type of analog
Input/
Signal
Output
Voltage
AI1
Current
Voltage
AO1
Current
Table 2: Configurations of the RS485 configuration
Communication Switch
RS485
(*) No other combinations of the switches are allowed.
This module has a connector
use of the Flash Memory Module (CFW500-MMF), which
allows data transfer between inverters. For further details
on this accessory, refer to the installation, configuration
and operation guide of the CFW500-MMF.
input and output signal
Setting of Range of
Switch S1
S1.1 = OFF
0...20 mA
S1.1 = ON
4...20 mA
S1.2 = ON
0...20 mA
S1.2 = OFF
4...20 mA
switches
S1.3 = OFF and
S1.4 = OFF
S1
(*)
S1.3 = ON and
S1.4 = ON
(figure
IOR Plug-in Module
Parameter
Signal Settings
0...10 V P0233 = 0 or 2
P0233 = 0 or 2
P0233 = 1 or 3
0...10 V P0253 = 0 or 3
P0253 = 1 or 4
P0253 = 2 or 5
Switch
Setting
RS485
termination
OFF
RS485
termination
ON
A.2) to enable the
CFW500-IOR-B | 9
Option