Mains Power - Klark Teknik DM8008 Guia De Inicio Rapido

10
DM8008
3. Front and Back Panel
(1)
(2) (3)
(1) STATUS LED indicates the overall system status (Green = OK; Red =
ERROR).
(2) POWER connection accepts the included IEC power cable.
(3) ULTRANET IN/OUT connections offer proprietary ULTRANET networking
capabilities through by using CAT5 cables with RJ45 connectors. ULTRANET
allows the user to transmit unidirectionally up to 16 independent channels
of 24-bit audio. Up to 7 devices can be connected in series on a single
ULTRANET cable. DM8008 uses ULTRANET to connect with the main
DM8000 unit.
(4) OUTPUTS section offers 8 output channels of balanced analogue audio
using Euroblock connectors.
(5) MODE switch determines whether the DM8008 outputs channels 1–8 or
9–16.

Mains power

Each mains inlet should be sourced from its own separate
wall-mounted mains outlet socket. Otherwise, both mains
sources must be suitably distributed so as to meet local
safety regulations.
(4)
4. Analogue Audio Connectors
To ensure the correct and reliable operation of the equipment, only high quality
balanced, screened, twisted pair audio cable should be used. XLR connector
shells should be of metal construction so that they provide a screen when
connected and, where appropriate, they should have Pin 1 connected to the
cable screen.
DM8008 uses Euroblock connectors for all analogue audio connections.
The following graphics offer guidance for correctly wiring common audio
connectors (XLR, ¼", RCA) to the Euroblock connections.
1
X
1
3
+
N/C
+
T
X
S
1. Balanced and unbalanced outputs. Euroblock to female XLR (balanced)
and male RCA (unbalanced) with the following pinouts:
XLR: 1 = ground; 2 = hot (+); and 3 = cold (-).
RCA: Sleeve = ground; Tip = hot (+); Ring = not connected.
5. Specifications
Analogue Outputs
Number of channels
Type
Output impedance
ULTRANET Digital Network
Number of channels
Sampling rate
Latency
Connector
Cable
Cable length
Performance
Frequency response
THD+N (20 Hz to 20 kHz @ 0 dB gain +4 dBu output)
Dynamic range
D/A conversion
Power Requirements
Voltage
Frequency
Consumption
Dimensions / Weight
Dimension (H x W x D)
Weight
Temperature Range
Operation
Storage
2
Due to a policy of continual improvement, KLARK TEKNIK reserves the right to alter the function or specification at any time without notice.
S
T
8
Euroblock (balanced)
100 Ω, balanced
16 in / 16 out
48 kHz
< 0.5 ms
2 x RJ45
SFTP CAT 5e TIA / EIA 568B
up to 75 m / 250 ft
20 Hz to 20 kHz (±0.4 dB, input to output @ +4 dBu)
< 0.004%
> 110 dB (20 kHz BW, input to output @ +24 dBu)
multi-bit ΣΔ
100-240 V ~
50 / 60 Hz
12 W
49 x 483 x 165 mm (1.9 x 19 x 6.5")
2.0 kg (4.4 lbs)
+0° C to +45° C
-20° C to +60° C
11
Quick Start Guide