Velleman DVR16M Manual De Instrucciones página 16

Pressing the PIP button ( ) will turn all targets on the screen ON or OFF (see below).
3) Set Sensitivity
Press the "SLOW" button to adjust the detection sensitivity, which focuses on both motion and brightness changes.
The value is shown between columns 7 and 8 (see figures above) and the default value is set at 32. A low value
means high sensitivity and vice versa. The minimum value (max. sensitivity) is 001; the maximum value is 255.
A motion detection will make the concerned channels appear in between the regular channel switching, like: 1-x-2-x-
3-x-4-x-5-x-...-x-16-x-1x--2-..., with x representing one (or more) motion detected channels.
h) Event List
Press the MENU button on the front of the device, enter the password
and confirm it by pressing ENTER (cf. "4a: Open Main Menu" on p. 7)
Press or until 'EVENT' is selected (cf. figure on the right).
Press ENTER to see the entire 'list of events'. A screen as shown on
the right will be displayed.
Press or to switch pages (8 events on 1 page) and press or
to select the desired event. Press ENTER to play it.
Possible event codes:
M-HDD / S-HDD WARNING: Master/Slave HDD might be failed.
M-HDD / S-HDD LOSS: Master/Slave HDD does not exist/not found.
M-HDD / S-HDD ERROR: Error on Master/Slave HDD
HDD FULL: HDD is full
SYSTEM ERROR: System failure
----02 VLOSS: Video loss on channel 2
----03 ALARM: External I/O alarm on channel 3
POWER RESTORE: Power restore.
DVR16M
M-HDD WARNING 2002-JAN-01 03:00:00
M-HDD LOSS
M-HDD ERROR
S-HDD WARNING
HDD FULL
SYSTEM ERROR
----02 VLOSS
----03 ALARM
◄: Page Up ►: Page Down ◄+►: CLEAR
- 16 -
(MENU)
SEARCH
TIMER
RECORD
CAMERA
SYSTEM
► EVENT
2002-JAN-01 03:00:00
2002-JAN-01 03:00:00
2002-JAN-01 03:00:00
2002-JAN-01 03:00:00
2002-JAN-01 03:00:00
2002-JAN-01 03:00:00
2002-JAN-02 03:00:00
VELLEMAN