Battery Disposal; Part List - Bestway AquaGlide 58620 Manual Del Propietário

properly. Recycling is required; please contact your local
authorities for more information.
- External adaptor and charging base:
• Never use the external adaptor and charging base for
anything other than charging the battery of the robot
that is supplied in the same pack.
• The external adaptor and charging base should not be
used outdoors, nor should it be exposed to rain,
humidity, any liquid or heat.
• The transformer (or external adaptor) is to be located
outside zone 1.
• Keep the external adaptor and charging base out of
reach of children.
• Never use the external adaptor and charging base if
any damage is detected.
• DO NOT handle the external adaptor and charging
base with wet hands.
• Keep the external adaptor disconnected from power
when it is not in use.
• Never attempt to open the external adaptor.
• If the supply cord is damaged, it must be replaced by
the manufacturer, its service agent or an equally-qualified
person in order to prevent hazards of any kind.
• Make sure the robot is completely dry before charging.

BATTERY DISPOSAL:

Recycling is required, please contact your local authority
for information.
• The battery must be removed from the pool vacuum
before it is scrapped.
• The pool vacuum must be disconnected from the supply
mains (electrical outlet) when removing the battery.
• The battery must be disposed of safely and properly.
CAUTION!
- This robot is designed for underwater use only; it is not
an all-purpose vacuum cleaner. DO NOT attempt to use
it to clean anything other than your pool.
- Use only original accessories delivered with this product.
- DO NOT use this robot right after pool-shocking. It is
recommended to first leave the pool circulating for at
least 24-48 hours.
- If you are planning on using the robot in a saltwater pool,
make sure all salt are dissolved before placing it into the
water.
- It is not recommended to use this robot with another
automatic cleaner/cleaner simultaneously.
- Avoid picking up hard, sharp objects with this product
which may damage the robot and filter.
- To avoid damaging the external adaptor and charging
base, do not attempt to carry the robot by the cable of
external adaptor or pull the cable to disconnect it from
the power source and charging base.
- Charge the robot indoors in a clean, dry area with good
ventilation and away from sunlight.
- DO NOT leave the robot charged for over 10 hours.
- If the robot will not be used for an extended period, detach
it from the charging base and use a damp cloth to clean
and dry the robot and its accessories. Make sure to charge
the robot to about 30% to 50% of the battery capacity
before it is stored. Store in a well-ventilated area away
from sunlight, heat, ignition sources, pool chemicals, and
children. Recharge the robot every three months.
- All actions concerning the disassembly of the swivel
head (ie. battery disposal) can only be carried by an
authorized technician.
Above warnings and cautions are not intended to
incorporate all possible instances for risks and / or
severe injuries. Pool / spa owners should always
exercise extra caution and common sense when utilizing
the product.
SAVE THESE INSTRUCTIONS

Part List

5
7
Part No. Part Code QTY
1 P05622 1
2 P05623 1
3 P05625 1
4 P05624 1
5 P05620 1
6 P03880 1
7 P03879 1
3
1
1
6
The robot has a water-propelling nozzle at the
bottom of the swivel head. Water is first sucked in
through the suction mouth at the bottom of the
robot, which then goes through the filter and is
discharged via the propelling nozzle. Water jetting
from the nozzle propels the robot forward. Once the
robot stops against an obstacle such as the pool
wall, its side flap sways and its swivel head turns
180 , allowing the robot to move in the opposite
o
direction. The robot moves in a generally straight
pattern in one direction and in an arc pattern in the
other direction. The robot vacuums the pool bottom
as it moves, collecting debris in its compartment.
2
3
4