Troubleshooting - Bestway AquaGlide 58620 Manual Del Propietário

3. Remove the battery pack to expose the PCBA. To detach the battery connection wire,
press the clip on the connector and then pull it out. NOTE: Wrap the connector immediately
with insulating tape in order to avoid short circuit caused by contact of both wire terminals.
DISPOSAL
Waste electrical products should not be disposed of with household waste. Please recycle where facilities exist.
Check with your local authority or retailer for recycling advice.

TROUBLESHOOTING

Problem
Robot does not capture the debris
Robot stopped moving in the middle
of pool but swivel head is still turning
Swivel head rotates repeatedly
Robot does not cover the entire pool
Robot moves along the pool wall
Robot moves slowly or does not
move at all.
Possible Cause
Battery is running out
Impeller is jammed
Suction mouth is clogged
Impeller is broken
Debris compartment is full
Robot stopped by obstacle or large
creases in the pool liner.
Robot is stopped by suction from the
main drain of pool floor
Air trapped inside the robot
Debris compartment is full
Operation time is shorter as expected
Moving direction is interrupted by
water circulation generated by
filtration system
Wheel is jammed
Position of locking pin is not set properly.
Algae renders the pool floor slippery
which results in the robot going in circles.
Position of locking pin-is not set
properly / robot facing direction
is wrong at beginning.
Debris compartment is full or filter
cover is clogged.
Suction mouth is clogged
Impeller is jammed
Charge the robot again.
Power off the robot and inspect the hole under the swivel head to
see if the impeller is jammed by large debris. For assistance, please
visit the support section on our website, www.bestwaycorp.com.
WARNING! Make sure the robot is off before the unit is serviced.
Remove clogged objects from the suction mouth.
For assistance, please visit the support section on our website,
www.bestwaycorp.com.
Clean both debris compartment and filter cover.
Check to see that if there is anything obstructing the cleaner.
Remove the obstacle.
Turn off the filtration system as instructed in manual.
The swivel head may rotate repeatedly for a few minutes once
the robot sinks to the pool bottom.
This phenomenon will stop once the air trapped inside the robot
is gradually discharged and the robot will begin to move regularly.
Clean the debris compartment
Clean the filter compartment and recharge the robot for 6 hrs
Turn off the filtration system (as instructed in filtration manual) at
least 15 minutes before robot operation.
Check and remove debris from the wheel.
Follow instruction to adjust the locking pin position.
Scrub the pool bottom and robot wheels to remove the algae
Follow instruction to adjust locking pin setting. Make sure that
robot's front/back faces the pool wall at beginning.
Clean the debris compartment. Flush the screen with water to
remove small particles. If brush is deem necessary, use a soft
brush to clean the screen gently.
Note: make sure that the filter cover is In place before next operation
Remove clogged objects from the suction mouth
Power off the robot and inspect the hole under the swivel head to
see if the impeller is jammed by large debris. For assistance, please
visit the support section on our website, www.bestwaycorp.com.
WARNING! Make sure the robot is off before the unit is serviced.
7
Solution