temperature for storage should be 10˚C – 25˚C (50˚F – 77˚F). NOTE: A higher temperature during storage may
reduce the battery life.
BATTERY DISPOSAL:
Recycling is required; please contact your local authority for information.
• The battery must be removed from the pool vacuum before it is scrapped.
• The pool vacuum must be disconnected from the supply mains when removing the battery.
• The battery is to be disposed safely and according to local ordinances or regulations.
• Never attempt to disassemble a battery pack.
• Do not expose the battery to fire or intense heat as this may result in an explosion.
• Avoid a possible short-circuit by wrapping the wire ends with insulating tape.
CAUTION!
If a battery leak occurs, avoid contact with the leaking fluids and place the damaged battery in a plastic bag.
- If leaking fluids come in contact with skin and clothing, wash immediately with plenty of soap and water.
- If leaking fluids come in contact with eyes, immediately flush eyes with cool running water for at least 15 minutes and
do not rub them. Seek medical attentionas soon as possible.
TROUBLESHOOTING
Problem
Pool vacuum does not
capture the debris
Debris escapes from the
filter
Debris goes outside the
filter bag
Pole connector cannot be
secured in assembly
Pool vacuum cannot be
charged / recharged
Suction head does not
move smoothly
DISPOSAL
Do not dispose of electrical appliances as unsorted municipal waste, use separate collection
facilities. Contact your local government for information regarding the collection systems
available.
If electrical appliances are disposed of in landfills or dumps, hazardous substances can leak
into the groundwater and get into the food chain, damage your health and well-being.
When replacing old appliances with new ones, the retailer is legally obligated to take back your
old appliance for disposal free of charge.
Possible Cause
Battery is running out
Impeller is jammed
Impeller is broken
Filter is full
Suction nozzle flap is
broken
Filter bag is damaged
Side pin is broken
Battery is damaged
Contact plates of the
charger base and unit are
not connected
External adaptor is out of
order
Ball-wheel is jammed
Meaning of crossed-out wheeled dustbin:
Solution
Charge the battery again.
Power off the pool vacuum and visually check the gap
in middle of the pool vacuum to see if the impeller is
jammed by larger debris. If necessary, contact your
dealer for further instructions.
Contact your dealer for impeller replacement.
Clean the filter.
Contact dealer for replacement part and instruction.
Replace with a new filter bag.
Replace with a new pole connector.
Contact dealer for battery replacement.
WARNING!
DO NOT open the pool vacuum and replace the battery
by yourself. This could result in severe or fatal injury and
the warranty will be voided as a result.
Make sure that the charger base is assembled on the
unit properly so that the contact plates are touching.
Contact dealer for replacement.
WARNING! Using the wrong external adaptor will result
in damaging the pool vacuum / battery and voiding the
warranty as a result.
Push the ball wheel out of the cavity by inserting a small
tool into the small hole at the top of the cavity. Clean it
out and push it back into the cavity after cleaning.
6
S-S-005121