Maintenance Schedule - MoJack EZ Max Instrucciones Para El Montaje Y La Operación

Maintenance Schedule

• Before each use, always check for any worn, loose or
damaged parts on the MoJack EZ Max. If any damaged
parts are present, do not use the MoJack EZ Max and
contact MoJack at 1-877-575-3173.
• Clean and oil the entire screw thread after every fifty (50)
uses or at least once a year using light machine oil.
• Place lithium grease between the Crank Handle Base
and the brass bearing after every fifty (50) uses or once
a year. Without weight on carrier, lift the Crank Handle
to create a small gap between the brass bearing and
the Crank Handle Base. Use a small brush to apply the
lithium grease between the two surfaces.
• Spray grease or lube in Carrier Locking Handle pivot after
every fifty (50) uses or at least once a year.
• Wipe clean and lightly apply grease to front and back of
Tower Assembly after every fifty (50) uses or at least once
a year.
MoJack EZ Max Lift
Carrier
Locking
Handle
pivot
Tower
Assembly
20
Crank Handle
Base
Brass Bearing
Screw Thread
MoJack EZ Max Lift
Supported Tire Sizes
Wheel Pads accommodate wheel sizes from
10" – 17"
(25cm – 43cm)
Not for use with tires over 17" (43cm) in size
21