Kiddy energypro Instrucciones De Operación página 9

3. Installation on the airplane
If your child seat is equipped with k-fix connectors, they have to be
retracted into the seat. An aircraft installation is not possible when the
k-fix connectors are extended. Check child seat operating manual.
The child seat always has to be secured with the safety belt, even
when the "Fasten your seat belt." signal is switched off. A unsecured
child seat could injure passengers in case of an accident, turbulences
or an emergency landing.
3.1 Installation with impact shield (9 - 18 kg)
Place the child car seat on the respective seat on the plane and fold the
armrests of the plane seat upwards.
Place your child in the child car seat and move the impact shield into the
guide slots of the car seat.
Feed the belt through the impact shield belt
guides (A) and close the belt buckle (B).
Make sure that the belts are not twisted.
Tighten the belt by pulling the loose end.
It is possible that the child car seat cannot
be fastened as described. If the belt buckle
is located in the area of the impact shield's
belt guides, this could prevent the clip from
locking in place or the correct tightening of
the belt.
2
ENG