Electrical Safety - Silverline 913738 Manual Del Usuario

913738
Work area safety
a) Do not operate electrical devices in explosive
atmospheres, such as in the presence of flammable
liquids, gases or dust. Electrical devices create sparks
which may ignite the dust or fumes.

Electrical safety

a) Electrical plugs must match the outlet. Never modify the
plug in any way. Do not use any adapter plugs with
earthed (grounded) devices. Unmodified plugs and
matchingoutlets will reduce risk of electric shock.
b) Avoid body contact with earthed or grounded surfaces,
such as pipes, radiators, ranges and refrigerators. There
is an increased risk of electric shock if your body is earthed
or grounded.
c) Do not expose non-waterproof electrical devices to rain
or wet conditions. Do not submerge non-pressure-rated
devices in water. Water entering an electrical device will
increase the risk of electric shock.
d) Do not abuse the power lead. Never use the lead for
carrying, pulling or unplugging the device. Keep lead
away from heat, oil, sharp edges or moving parts.
Damaged or entangled power leads increase the risk of
electric shock.
e) If operating an electrical device in a damp location is
unavoidable, use a residual current device (RCD)
protected supply. Use of an RCD reduces the risk of
electric shock.
WARNING: When used in Australia or New Zealand, it is
recommended that devices are ALWAYS supplied via Residual
Current Device (RCD) with a rated residual current of 30mA
or less.
Personal safety
a) Stay alert, watch what you are doing and use common
sense when operating an electrical device. Do not use
potentially dangerous electrical devices while you are
tired or under the influence of drugs, alcohol or
medication. A moment of inattention while operating
potentially dangerous devices may result in serious
personal injury.
b) Use personal protective equipment including eye
protection where appropriate. Protective equipment used
for appropriate conditions will reduce personal injuries.
c) Prevent unintentional starting. Ensure the switch is in
the off-position before connecting to a power source.
Carrying electrical devices with your finger on the switch or
energising devices that have the switch on invites accidents.
d) Do not overreach. Keep proper footing and balance at
all times. This enables better control of the device in
unexpected situations.
Use and Care
a) Do not force the device. Use the correct device for your
application. The correct device will do the job better and
safer at the rate for which it was designed.
b) Do not use the electrical device if the switch does not
turn it on and off. Any device that cannot be controlled with
the switch is dangerous and must be repaired.
c) Disconnect the power source before making any
adjustments, changing accessories, or storing electrical
devices. Such preventive safety measures reduce the risk of
starting the device accidentally.
Video Inspection Camera
d) Store idle devices out of the reach of children and do
not allow persons unfamiliar with the device or these
instructions to operate it. Electrical devices may be
dangerous in the hands of untrained users.
e) Maintain electrical devices. Check for defects of
parts and any other condition that may affect the
device's operation. If damaged, have the device repaired
before use. Many accidents are caused by poorly
maintained electrical devices.
f) Use the device and its accessories in accordance with
these instructions, taking into account the conditions
and the task to be performed. Use of the device for
operations different from those intended could result in a
hazardous situation.
Service
a) Have your electrical devices serviced by a qualified
repair person using only identical replacement parts.
This will ensure that the safety of the device is maintained.
Additional Safety Notes
• The unit is not shock resistant. Do not drop the unit from
height or otherwise subject it to high impacts
• The camera lens and cable are water resistant when the
unit is fully assembled. The main unit with LCD screen is not
water resistant
• Do not allow water or other liquids to enter the unit. Do not
use the camera if condensation forms inside the lens; allow
moisture to evaporate before using
• Turn off the system when it is not in use
www.silverlinetools.com
5