Environmental Protection - Worx WX615 Manual Original

Replacing a drive belt
WARNING:
• Remove the plug from the
socket before carrying out
any adjustment, servicing or
maintenance.
• The cutting blades will be
turning and may cause injury.
Loosen the screws and remove belt
cover. remove worn drive belt from
large pulley (b) and pinion (c) and
clean them. Place the new drive belt
on the top of pinion and turning it
manually, press it on the large pulley
(b). Make sure the drive belt runs
exactly along the length grooves of the
pinion and the pulley. Place the belt
cover back and tighten it with screw.
MAINTENANCE
Remove the plug from the socket before
carrying out any adjustment, servicing or
maintenance.
Never use water or chemical cleaners to clean your
power tool. Wipe clean with a dry cloth. Always
store your power tool in a dry place. Keep the motor
ventilation slots clean. Keep all working controls
free of dust. Occasionally you may see sparks
through the ventilation slots. This is normal and will
not damage your power tool.
If the supply cord is damaged, it must be replaced
by the manufacturer, its service agent or similarly
qualified persons in order to avoid a hazard.
WORKING HINTS FOR
YOUR PLANER
Warning: Danger of kickback! Apply the
machine to the work piece only when
switched on.
The rate of planning and the depth of cut determine
the quality of the cut. For rough cutting, you can
increase the depth of cut. To achieve a smooth
cut, you will need to reduce the depth of cut and
advance the planer slowly across the workpiece.
The proper feed rate will depend on the type of
material being cut and the depth of the cut. When
planning hard materials (e.g., hardwood), as well as
when utilizing the maximum planer width, set only
low planning depths and reduce the planer feed as
required.
Practice first on a scrap piece of material to gauge
the correct feed rate and the cut dimensions.
Planer
ENVIRONMENTAL
PROTECTION
Waste electrical products must not be
disposed of with household waste. Please
recycle where facilities exist. Check with your
local authorities or retailer for recycling
advice.
See Fig.
J1, J2
PLUG REPLACEMENT (UK
& IRELAND ONLY)
If you need to replace the fitted plug then follow the
instructions below.
IMPORTANT
The wires in the mains lead are colored in accor-
dance with the following code:
BLUE =NEUTRAL
Brown = Live
As the colors of the wires in the mains lead of this
appliance may not correspond with the colored
markings identifying the terminals in your plug,
proceed as follows. The wire which is colored blue
must be connected to the terminal which is marked
with N. The wire which is colored brown must be
connected to the terminal which is marked with L.
Warning:
Never connect live or neutral wires to the earth ter-
minal of the plug. Only fit an approved 13ABS1363/A
plug and the correct rated fuse.
Note: If a moulded plug is fitted and has to be
removed take great care in disposing of the plug
and severed cable, it must be destroyed to prevent
engaging into a socket.
Connect
Blue to N
(neutral)
Outer sleeve
firmly clamped
13 Amp fuse approved
to BS1362
Brown L (live)
Cable grip
EN
11