Getting Started; Manual Operation - Klarstein Bormio Manual Del Usuario

EN
20

GETTING STARTED

Insert the plug into the socket. Press the on / off switch on the lower right side of the
device. If the device has been switched on, it can only be started via the remote control.
To do this, press the power button on the remote control.
Note: As soon as the device has been started via the remote control, it can be
operated via the control panel on the bottom left of the device as well as via the
remote control.

MANUAL OPERATION

Switch on the device via the main switch. The unit will beep once to indicate that it has
been switched on. The device is now in standby mode. Once the device has been
started via the remote control, it can be operated via the control panel in the lower left
corner of the device.
Adjust the heating power
• When you press the button for the first time, the unit will heat up with 1900 W of
power. The heating power indicator will light up red.
• The second time you press the button, the unit will heat up to 950 W of power. The
heating power indicator will light up blue.
• If you press the button a third time, the heating elements will be switched off and the
heating power indicator will disappear.
Adjust the brightness
• When you press the button for the first time, the coal and the flames will be at the
highest brightness level.
• If you press the button a second time, the coal and the flames will be at the middle
brightness level.
• If you press the button a third time, the coal and the flames will be at the lowest
brightness level.
• Pressing the button a fourth time will cause the coal and flames to go out.