Initial Settings; Adjusting Initial Settings; Setting The Fm Tuning Step; Switching Auto Pi Seek - Pioneer KEH-P4023R Manual De Operación

Initial Settings

Adjusting initial settings

Initial settings lets you perform initial set up of
different settings for this unit.
1 Press
SOURCE
off.
2 Press and hold until
AUDIO
in the display.
Press repeatedly to switch between the
AUDIO
following settings:
— —
STEP A-PI AUX
Use the following instructions to operate each
particular setting.
• To cancel initial settings, press
• You can also cancel initial settings by holding
down until the unit turns off.
AUDIO
19 En
and hold until the unit turns
appears
STEP
.
BAND

Setting the FM tuning step

Normally the FM tuning step employed by seek
tuning is 50 kHz. When AF or TA are on the tun-
ing step automatically changes to 100 kHz. It
may be preferable to set the tuning step to 50
kHz when AF is on.
1 Press to select
AUDIO
Press repeatedly until
AUDIO
the display.
2 Select the FM tuning step with 2/3.
Pressing 2/3 will switch the FM tuning step
between 50 kHz and 100 kHz while AF or TA is
on. The selected FM tuning step will appear in
the display.
Note
• The tuning step remains at 50 kHz during
manual tuning.

Switching Auto PI Seek

The unit can automatically search for a different
station with the same programming, even dur-
ing preset recall.
1 Press to select
AUDIO
Press repeatedly until
AUDIO
the display.
on or off with 5/∞.
2 Select
A-PI
Pressing 5/∞ will switch
off and that status will be displayed.
.
STEP
appears in
STEP
.
A-PI
appears in
A-PI
between on and
A-PI