Power Supply - BSVILLAGE PISCINE DOLPHIN WAVE 100 Instrucciones De Uso

3) Op era t i o n

3.1) Power Supply

At the front section there are lights that indicate when the DOLPHIN WAVE 100 is operating or when the filter
bag needs to be cleaned or washed.
•
� Il
@
�
Reset
Note:
to clean the bag when filter bag light turns on.
The DOLPHIN WAVE 100 pool cleaner and power supply have been designed far safe, maintenance-free outdoor
use.
3.2) OOL PHIN WAVE 100 lnstallation:
Uncoil cab le (5 page-9) and connect to the DOLPHIN WAVE 100 power supply. Release minimal required floating
cable length to ensure proper pool coverage.
Far best operati on of the DOLPHIN WAVE 100 Swivel [6 page-9] cab le leave excess cab le roll ed outside of the
pool [Fig A].
Piace cab le and the DOLPHIN WAVE 100 in pool; gently rock the DOLPHIN WAVE 100 from side to side releasing
trapped air unti I the DOLPHIN WAVE 100 sinks slowly to the pool bottom [Fig D].
Warning!
pump motor seals, thus invalidating the warranty.
Switch the power supply ON and let the DOLPHIN WAVE 100 work its wonders!
4)
THE DOLPHIN WAVE 100 model offers two modes of operati on - Automatic or Remote Contro I.
The DOLPHIN WAVE 100 will work in Automatic Mode unless changed to Remote Contro I mode, through the
Remote Contro I Unit (RCU).
4.1) Remote Contrai Mode
In Remote Contro I Mode, you can manoeuver the DOLPHIN WAVE 100 to give special attenti on to certa in areas
of the pool.
Move the Joystick in the direction you desire the DOLPHIN WAVE 100 to clean.
Note:
Cleaning Mode.
The RCU is also used to modify parameters and/or cleaning programs. These parameters have to be transmitted
from the RCU to the DOLPHIN WAVE 100 while it is working in the pool [see 5].
4.2) Automatic Cleaning Mode
In Automatic Cleaning Mode the DOLPHIN WAVE 100 calculates its own cleaning path.
The flow chart in 5.3 represents the factory pre-set parameters and cleaning programs.
These may be adjusted to suit your preferences by means of the RCU.
Once set, the parameters will rema in in the DOLPHIN WAVE 100 memory unti I modified [see notes in 5.1].
Will lit up when switching ON power supply.
Will flash at initial performance of self test .
Will turn off automatically at the end of operation
Will remain unlit during normai operation .
Will lit up and flash when the filter bag fills up and needs cleaning.
Will remain lit when the filter bag is clogged and needs washing.
To reset filter bag indicator if indication light stays lit after the filter bag is already clean.
The filter bag light is a recommendation. Far best DOLPHIN WAVE 100 performance, it is recommended
Do not operate the DOLPHIN WAVE 100 out of the water. This may result in extensive damage to the
C l e a n i n g m o d e s
lf Joystick is not touched far 30 seconds the DOLPHIN WAVE 100 will switch back to enter
3
Automatic