Battery Replacement - BSVILLAGE PISCINE DOLPHIN WAVE 100 Instrucciones De Uso

5) R e m o t e C o n t rai Unit
These buttons are used far switching between menus and options.
This button is used to switch on the RCU, to select a required menu, to SENO or to SET a para meter or a program.
This button is used to EXIT tram a menu or move back a step.
This button is also used to turn off the RCU. Press EXIT a number of times unti I RCU turns off.
lf a parameter was modified, then just before final EXIT you may be required to send your new set of parameters.
ENTER/SENO/SET EXIT/BACK
5.1) Oescription and use of menus
5.1.1) C/eaning programs
• REGULAR- Floor and walls cleaning program.
• ULTRAclean - Slower movement and increase suction far special thorough cleaning.
ULTRAclean mode can only be selected tram
Note:
• WATERline - Far special attention to walls and water line.
Far efficient WATERline cleaning program, position the handle diagonally exactly as shown in
Note:
WATERline or ULTRAclean
lf you choose
memory far the next cycle. lnstead, the OOLPHIN WAVE 1 DO automatically switches to
• LAPpool - Suitable far this specific type of pool - narrow and long.
LAPpool
Note: lf you choose a cleaning mode, set the pool length alter setting this mode.
5.1.2) Parameters
• CYCLE-TIME - Choose the most suitable cycle time.
POOL-LENGTH
• - Program the pool length.
• CLIMB-EVERY - This option controls the trequency of wall climbing e.g.: at which trequency the OOLPHIN
WAVE 100 should climb on the walls.

5.2) Battery Replacement

lf the massage "Low Battery'' appears on the RCU screen:
• Open the battery cover.
• Remove all used batteries tram the RCU.
• Piace two 1.5 V AAA batteries into the RCU as shown in the drawing inside the battery housing.
• Close the battery cover.
lf you are not using your RCU for more than 6 months - remove batteri es.
-
5.3) Remote Contro/ Flow Chart see next page.
4
(RCU)
Menu
Battery cover
REGULAR mode.
modes, these parameters will not rema in in the OOLPHIN WAVE 1 OD
[Fig B].
REGULAR mode.