Software Update - Herth+Buss AirGuard Manual Del Usuario

Operating Instruction

10. Software update

1. Connect the AirGuard with your PC or
laptop using the USB cable supplied.
2. If the supplied software is already installed,
the following window appears:
Wait until the update is complete. Your H+B AirGuard may be rebooted several times
during this process. The USB cable should therefore only be removed when the relevant
message appears on the display of the device and the update is 100% complete.
www.herthundbuss.com
The serial number of the AirGuard
is shown:
1. Select "Open File" .
2. Now open the downloaded update file
and check whether it corresponds to the
designation of your serial number.
3. Start the update with the "Program" key.
95990001
24