Technical Features - Laica BM1001 Instrucciones Y Garantía

English
GB
Do not use any chemical or abrasive products to clean the monitor.
Ensure that no liquids enter the appliance.
• This appliance is not waterproof.
• Place the device in the supplied case and, to store it, observe the environmental conditions stated
here below.
SPECIAL CASES
If the following circumstances occur:
1) After pressing the 0/I key the reading does not start.
• Check the batteries and replace them if needed.
• Clean the contacts of the batteries with a dry cloth.
2) Nothing appears on the display when the M key is pressed.
• The batteries are flat.
3) The batteries do not last long.
• use alkaline batteries to increase working autonomy. If normal zinc-carbon batteries are used
they will need changing more often.
4) You cannot complete a reading.
• check the batteries and change them if needed.
5) The blood pressure levels are different with each reading - the readings are very low or very high.
• the measuring position is not correct - Read the paragraph "Correct measuring position" again.
• the blood pressure readings vary constantly depending on the time of day and the state of
nerves of the person. Read the paragraphs "Warnings" and "Important" again.
6) The heart beat readings are too high or too low:
• The person moved while the reading was being taken.
• The reading was taken after physical exertion. Read the paraghaphs "CORRECT MEASURING
METHOD", "WARNINGS" and "IMPORTANT" again.
7) On the display, appears the symbol
• It has been detected the presence of an irregular pulse (arrhythmias). Repeat the measurement.
If the symbol appears again, refer to a physician to establish the most
WRIST BLOOD PRESSURE MONITOR
.
38
Instructions and guarantee
suitable treatment to be followed.
COMPONENTS
1) LCD DISPLAY
2) 0/I KEY
3) M KEY
4) ARMBAND
5) BATTERY COMPARTMENT
6) BATTERIES
7) CASE

TECHNICAL FEATURES

• Pressure indication range: between 0 and 300 mmHg (arm cuff pressure)
between 40 and 180 pulsations/min. (pulse frequency)
• Precision: ±3 mmHg (arm cuff pressure)
± 5% of the read value (pulse frequency)
• Inflating and deflating: automatic
• Power supply: 2 alkaline batteries type AAA (LR03)
• Memories: 60 Memories
• Working conditions: between +5°C and +40°C; 90% relative humidity or lower
• Storage conditions: between -20°C and +55°C; 90% relative humidity or lower
• Atmospheric Pressure: 80kPa – 105 kPa
• Wrist circumference: between 140 and 195 mm approx.
• Battery life: about 180 readings
• Dimensions: 86x68x32 mm
• Weight: about 130 g (without alkaline batteries)
Important! Read the instructions carefully
Type BF apparatus
English
39
GB