What To Do "When - Fieldmann FVC 4001-EK Manual Del Usuario

Ocultar thumbs Ver también para FVC 4001-EK:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 67
7. WHAT TO DO „WHEN..."
When...
The pump does not start
Not fl owing
The pump does not
turn off
Insuffi cient fl ow
The pump turns off
after a short time
Note: Not covered by warranty:
Damage to the rotating mechanical gasket caused by running the pump empty, or by
foreign objects
in the water
Blocking of the running wheel by foreign objects
Damage during transport
Damage caused by unprofessional alterations by persons
SUBMERSIBLE PUMP
Causes
No power supply
The fl oat does not switch
The suction sieve is
clogged
The pressure hose is bent
The fl oat cannot fall lower
The suction sieve is
clogged
Lowered pump capacity
due to dirty and silted
water
The temperature fuse stops
the pump due to dirty water
The water is too hot. The
temperature fuse stops the
pump
What to do „When..."
Repairs
Check the power supply
Move the fl oat to a higher
position
Flush out the suction sieve
with a current of water
Straighten the hose
Place the pump correctly on
the fl oor of the tank
Clean the suction sieve
Clean the pump and fl ush
the hose with clean water
Disconnect the power plug.
Clean the pump and the
pumping pit
Check that the maximum
water temperature of 35 °C
is not exceeded
USER'S MANUAL
9
EN

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Fvc 4002-ek

Tabla de contenido