Technical Data - MESTO 3132 Serie Manual De Instrucciones

EN

Technical data

Type of
device quantity
3132... 1.0 l
3132... 1.5 l
3132... 1.5 l
Welcome and congratulations
for purchasing your new pressure sprayer.
Thank you for the trust you have shown in our brand.
Intended Use
Pressure sprayers 3132... 1.0 l and 1.5 l are designed for spraying
detergents, disinfectants, anti-corrosion agents, impregnating agents
and other care products.
Not suitable for, and not to be used under any circumstances for:
• Wetting agents (surfactants), solvents, and liquids containing solvents
which can cause or promote cracking in the applied plastics.
• highly viscous or sticky liquids or liquids that leave residue which
cannot be completely rinsed out of the device.
safety instructions of the agent manufacturer. Products other than those
approved by the manufacturer as well as
The manufacturer shall not be liable for any resulting damages or for
Your Safety
Do not leave the device in the sun.
Check each time before using:
• Are all parts that are under pressure and convey liquids free of
damage?
• Are those parts functioning properly?
Replace devices that are damaged or not functioning properly
immediately.
Follow the spray manufacturer's instructions.
Original operating instructions
2293405
Total Max.
contents pressure
1.15 l 3 bar
1.60 l 3 bar
2.00 l 3 bar
Max. Weight
temperature when empty
30 °C 365 g
30 °C 410 g
30 °C 470 g
Never direct spray at persons, animals, or bodies of water.
Do not unscrew the pump from the tank when device is under pressure.
Do not blow through clogged nozzles or valves with your mouth.
Making the Device Ready for Use
• Turn the pressure release valve on the side until the pressure is
released from the tank.
• Unscrew the pump from the tank.
•
• Screw the pump tightly onto the tank.
• Generate pressure in the tank by activating the pump
Use
• To spray, activate the lever on the pump.
• Releasing the lever interrupts the spray process immediately.
• The spray pattern can be optimally adjusted by turning the nozzle.
After Usage
• Turn the pressure release valve on the side until the pressure is
released from the tank.
• Unscrew the pump from the tank.
• Never leave liquid in the device.
Empty and rinse the device with clear water.
• Do not dispose of residue as wastewater through the drain!
Dispose of surplus environmentally harmful products as hazardous
waste.
MESTO Spritzenfabrik Ernst Stockburger GmbH
Ludwigsburger Straße 71, D-71691 Freiberg/Neckar, www.mesto.de
Material of Max. pumping
tank volume
Polyethylene 1.15 l/min/3 bar
Polyethylene 1.15 l/min/3 bar
Polyethylene 1.15 l/min/3 bar
0719