Maintenance And Service; Maintenance And Cleaning; After-Sales Service And Application Service - Bosch GLM 40 Professional Manual Original

34 | English
Cause
Obstruction in the path of the laser beam
The indicator remains unchanged or the measuring tool reacts unexpectedly when
a button is pressed
Software error
The measuring tool monitors for correct operation in every measurement. If a defect is
detected, all indicators on the display will flash. In this case, or if you are unable to rectify
an error using the corrective measures above, send the measuring tool to Bosch cus-
tomer service via your dealer.

Maintenance and Service

Maintenance and Cleaning

Keep the measuring tool clean at all times.
Never immerse the measuring tool in water or other liquids.
Wipe off any dirt using a damp, soft cloth. Do not use any detergents or solvents.
Take particular care of the reception lens (11), which must be handled with the same
level of care you would give to a pair of glasses or a camera lens.

After-Sales Service and Application Service

Our after-sales service responds to your questions concerning maintenance and repair of
your product as well as spare parts. You can find explosion drawings and information on
spare parts at: www.bosch-pt.com
The Bosch product use advice team will be happy to help you with any questions about
our products and their accessories.
In all correspondence and spare parts orders, please always include the 10‑digit article
number given on the nameplate of the product.
Australia, New Zealand and Pacific Islands
Robert Bosch Australia Pty. Ltd.
Power Tools
Locked Bag 66
Clayton South VIC 3169
Customer Contact Center
Inside Australia:
1 609 92A 5DX | (27.01.2020)
Corrective measures
The laser point must be fully on the target
surface.
Remove the batteries, reinsert them and
restart the measuring tool.
Bosch Power Tools