Remote Control Operation; Testing Your Fan - Ellington REGATTO REG54BNK3 Guia De Instalacion

12. Remote Control Operation.

ON/OFF - turns wall control ON or OFF
slider switch (switch not functional on handheld
remote)
HIGH button - turns fan to HIGH speed
MED button - turns fan to MEDIUM speed
LOW button - turns fan to LOW speed
OFF button - turns fan OFF
L1 button - turns light kit ON/OFF when pressed
once; dims light kit when pressed and
held down

13. Testing Your Fan.

It is recommended that you test fan before finalizing
installation. Restore power from circuit box and light
switch (if applicable). Test wall control (optional
installation) by locating ON/OFF slider switch on wall
control, then set to the ON position. Test light and
dimmer function and then test fan speeds. Next,
locate handheld remote control. Test the light
ON/OFF function by pressing the L1 button; test the
dimmer function by pressing the L1 button and
holding it down for 1 second. Test fan speeds with the
different fan speed buttons. If the wall and/or
handheld remote control operates all of the functions
of the fan, battery has been installed correctly. If the
wall and/or handheld remote control do (does) not
operate all of the fan/light functions, refer to
"Troubleshooting" section to solve any issues before
contacting Customer Service.
Turn fan completely off before moving the reverse
switch (located on top of the motor housing).
(diagram 1) Set reverse switch to recirculate air
depending on the season:
- LEFT position in summer (diagram 2)
- RIGHT position in winter (diagram 3)
A ceiling fan will allow you to raise your thermostat
setting in summer and lower your thermostat setting
in winter without feeling a difference in your comfort.
Important: Reverse switch must be set either
completely to the LEFT or completely to the RIGHT for
fan to function. If the reverse switch is set in the
middle position (diagram 4), fan will not operate.
NOTE: If the wall control/handheld remote control
interferes with other appliances, turn off power and
go back to the instructions in Section 11 on the
previous page.
motor
housing
(topside)
diagram 1
diagram 2
page 10
-
1 1
wall control
remote control
reverse switch
diagram 3 diagram 4
handheld