Headset Charging; Status Led Indicators; Factory Reset; Questions Or Setup Issues - HyperX Cloud Buds Manual De Usuario

Headset Charging

When the headset is connected to a charger with the USB charge cable, the status LED will indicate
the charge status. The headset will take approximately 3 hours to fully charge.
Status LED
Breathing red
Off

Status LED Indicators

The status LED on the headset indicates the current state of the headset.
Status LED
Flash blue every 5 seconds
Flash blue every 2 seconds
Pairing mode

Factory reset

Factory Reset
To perform a factory reset on the headset, hold the power and volume up buttons together for 7
seconds. The status LED will flash red and blue 2 times, followed by solid red for 1 second. At the
same time, the headset will play two low beeps. After this, the headset will automatically turn off.

Questions or Setup Issues?

Contact the HyperX support team at: hyperxgaming.com/support/headsets
Document No. 480HX- HEBBXX.A01
Charging Status
Charging
Fully charged
Headset Status
Connected to a device
Not connected to a device
Flashing red and blue
Flash blue 5 times and light up red for 1 second
HyperX Cloud Buds Page 7 of 7