Clutch Adjustment; Parts And Maintenance - Ingersoll Rand QA1L Serie Especificaciones Del Producto

EN

Clutch Adjustment

Disconnect the air supply from the Tool before proceeding.
1. Rotate the Adjusting Hole Cover to expose the clutch adjusting hole in the Clutch Housing.
2. Insert a 1/4" hex wrench into the Spindle or a wrench on the square driver and rotate the
clutch mechanism until the area having an opening between the faces of the Clutch
Adjusting Nut Washer and Clutch Adjusting Nut is visible.
3. Using a screwdriver that has a #1 Philips tip, insert the tip of the screwdriver into the opening
and rotate the screwdriver to adjust the Clutch. Rotate the screwdriver clockwise to decrease
Clutch Spring tension and torque and counterclockwise to increase the tension and torque.
The most satisfactory adjustment is usually obtained by using the tool on the actual
application and increasing or decreasing the delivered torque until the desired
setting is reached. In any event, it is recommended that final adjustment be made by
gradual progression.

Parts and Maintenance

When the life of the tool has expired, it is recommended that the tool be disassembled,
degreased and parts be separated by material so that they can be recycled.
The original language of this manual is English.
Tool repair and maintenance should only be carried out by an authorized Service Center.
Refer all communications to the nearest Ingersoll Rand Office or Distributor.
EN-2
WARNING
NOTICE
80167406_ed2