Panacom BB-2000 Manual Del Usuario página 4

OPERATIONS
1. Power supply: The unit can work either on the supplied battery pack (DC 9V
800mAh rechargable battery) or the DC power (via AC/DC adaptor).
2. Battery application: Push the battery door clip downwards following the
indicated direction, load 1pcs Li-ion battery in the direction shown, then
replace the battery door.
3. AC power: Insert one end of the AC/DC adaptor into the DC in (mirco USB
port) and the other end into the power outlet and refer to the following
precautions:
• When pulling out the AC/DC adaptor, it is better to hold the plug section.
• Do not touch the AC power supply plug when your hands are wet, since it may
cause an electric shock.
• Do not use any AC/DC adaptor of a output Avoltage over 9V, as this may cause
a fire or an electric shock.
4. When the product is not used for a long time, Set the function switch on
OFF position, pull out the AC/DCadaptor from the power supply socket and
take out the batteries to avoid battery liquid leaking out and damaging the
components inside the player.
5. Battery charge:Under a playing mode, the LCD display will show a battery
power level. means power full,
low or no power, to use the attached USB cable or AC/DC adaptor for battery
charge.
Battery charge by USB cable:
- install the battery into the battery house correctly,
- insert one terminal of the cable (USB jack) to PC output port or other device
with power bank or output ports ( the input voltage must not be exceeding 9V),
another terminal (mirco USB ) into DC in port for charging.
- The LCD will show a charging mode while charging, after 4-5 hours continueous
charging, the battery will be fully charged.
Battery charge by AC/DC adaptor:
- First Install the battery into the battery house correctly.
- Connect the attached USB cable with AC/DC adaptor, another end of mirco
USB jack into DC in .
- Plug the adaptor into AC power supply socket to start charging.
- The LCD will show a charging mode while charging, after 4-5 hours continueous
charging, the battery will be fully charged.
6. A fully charged battery will endure approximatelly 1-2 hours of continuous
playback, the plalying time may vary by the surrounding environment, the
volume level of the speakers and the battery conditions.
Cautions: Before charge to battery, be sure to set the function switch to be on
OFF position.
means power low, when battery is power