Default Configuration; Maintenance - TTI TG420 Manual Del Usuario

Default Configuration

Frequency
Range
Function
Amplitude
Symmetry
Offset
Input
Attenuation
Prog step
Sweep start
Sweep stop
Sweep rate
Sweep mode
The Manufacturers or their agents overseas will provide a repair service for any unit developing a
fault. Where owners wish to undertake their own maintenance work, this should only be done by
skilled personnel in conjunction with the service manual which may be purchased directly from
the Manufacturers or their agents overseas.
Cleaning
If the instrument requires cleaning use a cloth that is only lightly dampened with water or a mild
detergent.
WARNING! TO AVOID ELECTRIC SHOCK, OR DAMAGE TO THE INSTRUMENT, NEVER
ALLOW WATER TO GET INSIDE THE CASE. TO AVOID DAMAGE TO THE CASE NEVER
CLEAN WITH SOLVENTS.
14
10.000 kHz
20 kHz
SIN
5.0Vpp
50:50
00.0V
OFF
0dB
01
0.20 kHz
2.00 kHz
0.20s
OFF

Maintenance