Installation To Wood Stud Wall - PEERLESS ACWAC1/BK Guía Para La Instalación

1

Installation to Wood Stud Wall

NOTE: If installing SmartMount
Cable Management Columns remove end caps before installation.
Level column (A) and use as a template to mark two mounting holes along the center line of the wood
stud. Drill two 5/32" (4 mm) diameter holes 2.5" (64 mm) deep. Attach wall mount (A) to wall with
two wood screws (C) into stud center. Warning: Do not overtighten screws or damage may occur.
Warning: Wood screws must center in stud. Tighten fasteners then cover #14 x 2.5" wood screws (C)
with rubber caps (B).
Skip to step 2
END
CAP
A
WARNING
Do not over tighten screws, or damage may occur.
®
A/V Component Shelf (sold separately) or additional SmartMount
C
B
C
A
3 of 60
A
WARNING
Wood screws must
center in stud
STUD
TOP CUTAWAY VIEW
ISSUED: 04-14-10 SHEET #: 083-9011-1
®