PEERLESS ACWAC1/BK Guía Para La Instalación página 4

1
Installing to Solid Concrete or Cinder Block
® ®
NOTE: If installing SmartMount A/V Component Shelf (sold separately) or additional SmartMount
Cable Management Columns remove end caps before installation.
Level wall mount (A) and use as a template to mark two mounting holes. Drill four 13/32" (10 mm)
diameter holes 3" (76 mm) deep. Insert two anchors (D) into holes. Secure wall mount (A) with two
wood screws (C). Warning: Do not overtighten screws or damage may occur. Warning: Wood
screws must center in stud. Tighten fasteners then cover #14 x 2.5" wood screws (C) with rubber
caps (B).
END
CAP
CONCRETE CINDER BLOCK
A
D
A
C
B
4 of 60
ISSUED: 04-14-10 SHEET #: 083-9011-1