PIAA POWERSPORTS 510 Instrucciones De Instalación página 3

LAMP
INSTALLATION
• The installation area must be clean and level with enough working space
to complete the job without distractions.
• The PIAA lamps are to be mounted hanging down. For an upright mount
install lenses with PIAA logo right side up. To flip the lens follow the lamp
service diagram.
• For the lamp system to function properly the supplied PIAA harness
must be used.
• When mounting the lamps mount them in such a place that they are free
of obstructions.
• Do not modify the lamp system in any way or it will void the warranty.
• Do not mount the lamps in a place that will obstruct an existing
vehicle function.
• Do not mount them so low to the ground that they scrape.
• When a lamp mounting location has been decided a 10mm hole will be needed
to mount the lamp with the supplied mounting hardware. If a hole is not
available, one will have to be drilled.
• When lamp is mounted make sure to leave at least 1/8 inch clearance around
the lamp to avoid heat damage to any vehicle part.
3. 3. 3.