Placing The Transmitter And Receiver - Marmitek SURROUND ANYWHERE 220 Manual Del Usario

4. Placing the transmitter and receiver

For optimum reception, the receiver should be placed within the line
of sight from the transmitter. If possible, the receiver should be
placed right side up with its front toward the transmitter.
The transmitter should be placed at an elevation such that there are
no obstacles between the transmitter and receiver (line of sight) in an
area where there will be the least amount of traffic. We suggest that
you place the transmitter on top of your audio source. Example 1
shows the optimum placement of the transmitter and receiver.
The receiver can also be placed as shown in example 2. In this case, no
line of sight exists and the operating range is reduced.
You can mount the receiver vertically by using the 2 screw openings
at the bottom of the receiver. If the receiver is mounted vertically, the
operating range is reduced compared to mounting the receiver right
side up.
The receiver incorporates a directional antenna which prefers signals
transmitted toward the front of the receiver. Therefore, the front of
the receiver should always be facing toward the direction of the
strongest transmitter signal. By properly orienting the receiver,
interference from other signal sources can be minimized.
We suggest that you experiment with placement in order to find the
best location for the transmitter and receivers.
Note: This product will not work properly from within an enclosed
metal cabinet.
SURROUND ANYWHERE 220 5