Attaching The Fan Blades - THD RH5H1-ORB Guía De Uso Y Cuidado

Installation (continued)
5

Attaching the fan blades

NOTE: Your fan blades are reversible. Select the blade side
nish which best accentuates your decor. Failure to follow
above procedure could result in fan wobble.
□ Mount the blade holders (D) to the fan blades (E) using the
screws (1) provided – 3 per blade (Figure 10). Please note
the rubber washers are pre-attached to the blade holder
(D).
The fan blade assemblies attach to the motor using the blade
holder screws (2) that are pre-installed into the blade holder (D).
The procedure to attach blade assemblies is as follows:
1
E
D
THD_RH5H1_UD42.eg
Figure 10
□ Position the blade holder (D) under the motor such that the
alignment post on the blade holder ts into the slot (3) in
the motor (Figure 11).
□ Tighten the pre-installed blade holder screws (2).
□ Repeat these steps to install the remaining blade
assemblies.
3
Figure 11
8
D
2
18年11月07日 下午15:20