Balancing The Blades; Installing The Light Kit - THD RH5H1-ORB Guía De Uso Y Cuidado

Installation (continued)

Balancing the blades

All blades are grouped by weight. Because natural woods vary in
density, the fan may wobble even though the blades are weight
matched.
The following procedure should correct most fan wobble. Check for
wobble after each step.
Check that all blade and blade holder screws are secure.
Most fan wobble problems are caused when blade levels
are unequal. Check this level by selecting a point on the
ceiling above the tip of one of the blades. Measure this
distance as shown in Figure 12. Rotate the fan until the
next blade is positioned for measurement. Repeat for each
blade. Measurements should be within 1/8 in.
If blade wobble is still noticeable, interchanging two
adjacent (side by side) blades can redistribute the weight
and possibly result in smoother operation.
Figure 12
THD_RH5H1_UD42.eg

Installing the light kit

WARNING: To reduce the risk of electric shock,
disconnect the electrical supply circuit to the fan before
installing light kit.
CAUTION: Do not use pliers or screwdrivers to tighten
the thumb screws. Overtightening of the thumb screws may
crack the lamp shades.
Install a LED bulb (max. 9W, medium screw base) to the
lampholder (Figure 13).
thumb screws (Figure 14).
Touch Ceiling
Lamp Holder
9
1
LED Bulb
Figure 13
F
Figure 14
18年11月07日 下午15:20