Commissioning - GG emotron CDN-COM Serie Instructions De Montage

7

Commissioning

Preconditions for initial switch−on







Danger!
High hazard potential during commissioning
Incorrect settings may cause unexpected and dangerous motor and
system movements.
Possible consequences:
Protective measures:
CDN40-xxx, DE/EN/FR/ES/IT
The wiring unit is mounted and wired according to the instructions,
- directly on a motor clamping flange or
with the wall adapter on a suitable surface near the motor.
Connections with the mains, motor, etc. have been established.
The communication unit has been mounted and wired according
to the scheduled application.
- Input and output signals
- Fieldbus (depending on the version, only available optionally)
If required, the basic settings for "local mode" have been carried out.
- Potentiometer
The drive unit has been mounted and screwed together.
Use available control functions reasonably, e.g.
- Inhibit controller enable
- Set speed adjustment to the minimum setting.
Damage to material assets

Injury to persons

Clear hazardous area

Observe safety instructions and safety clearances

Commissioning 7
47