GG emotron CDN-COM Serie Instructions De Montage página 50

7 Commissioning
Commissioning
Proceed step by step:
48
Switch on the mains

Observe status display

After a short initialisation time, the display must be blinking green.
Set controller enable

After the set starting time, the motor must rotate with the set speed.
First check of the expected behaviour:

- Direction of rotation?
- Starting time?
- Speed?
- Speed control?
Check of optional control functions:

- Does the analog setpoint selection work?
- Do the digital control signals, e.g. limit switches, work?
- Does the change of direction of rotation work?
- Do the control signals over fieldbus work?
Switch off drive

- Reduce speed
- Inhibit controller enable
- Switch off
mains
Commissioning
CDN40-xxx, DE/EN/FR/ES/IT
7